Explorers kit for Arduino Revision as of 11:38, 6 November 2014 by Sandeep (Talk | contribs) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Kit Contains

• LCD 16 x 2
• DIP Switch
• LEDs 5mm x20
• LED RGB x2
• 7 Segment
• Buzzer
• Relay
• DC Motor
• Light Dependent Resistor (LDR)
• Temperature Sensor (LM35)
• IR pair
• Transistor BC547
• Resistors: 1K, 10K (10 each)
• USB Cable 1
• Jumper wires male to female x10
• Breadboard

Experiments

[−] Arduino Tutorials

  1 Blink a LED

  2 Read Switch and Display on LED

  3 Make some noise with buzzer

  4 Display colors with RGB LED

  5 Display numbers on Seven Segment Display

  6 Display letters, numbers and fun characters on LCD

  7 Blink LED with POT

  8 Lets measure the light in the room with LDR

  9 What is temperature there? with LM35

  A Can we turn on the bulb? with Relay

  Analog JoyStick with Arduino

  B Let the motors run!

  Building a LED matrixGame console with Arduino

  Explore Ping-Pong with Arduino

  GSM SIM800L Sheild with Arduino

  Interactive Menus for your project with a Display and an Encoder

  Setting up Bluetooth HC-05 with Arduino

  Setting up GPRS with SIM800L

  Smoke Sensor (MQ2) board

Differences between Arduino Uno R3 and Explore One

Feature	Arduino Uno R3	Explore One	Remark
USB to Serial IC	Atmega16u2	CP2102	The Arduino UNO R3 uses a dedicated micro-controller, the USB to serial firmware can be reprogrammed and upgraded. Explore One uses CP2102 from Si Labs.
Power Management	Uses comparator to detect USB power and jack power.	None	Makes better power management
Design Software	Eagle	KiCAD	KiCAD is opensource PCB Design Software, check our tutorials here
Manufacturing Country	Italy	India	hence a affordable here!