Difference between revisions of "Explorers kit for Arduino"
| Line 1: | Line 1: | ||
[[category: Arduino/Arduino Compatible]] | [[category: Arduino/Arduino Compatible]] | ||
| + | The Explorers kit is meant to get you started with micro-controllers and electronics in a simple way. There are 11 basics experiments you can do with this kit, you can assemble all the circuits on the breadboard and program it with the Arduino Software. | ||
| + | |||
[[File:Explorers Kit for Arduino.jpg|x380px|frameless|center]] | [[File:Explorers Kit for Arduino.jpg|x380px|frameless|center]] | ||
=Kit Contains= | =Kit Contains= | ||
Revision as of 11:46, 6 November 2014
The Explorers kit is meant to get you started with micro-controllers and electronics in a simple way. There are 11 basics experiments you can do with this kit, you can assemble all the circuits on the breadboard and program it with the Arduino Software.
Kit Contains
- LCD 16 x 2
- DIP Switch
- LEDs 5mm x20
- LED RGB x2
- 7 Segment
- Buzzer
- Relay
- DC Motor
- Light Dependent Resistor (LDR)
- Temperature Sensor (LM35)
- IR pair
- Transistor BC547
- Resistors: 1K, 10K (10 each)
- USB Cable 1
- Jumper wires male to female x10
- Breadboard
Experiments
Differences between Arduino Uno R3 and Explore One
| Feature | Arduino Uno R3 | Explore One | Remark |
|---|---|---|---|
| USB to Serial IC | Atmega16u2 | CP2102 | The Arduino UNO R3 uses a dedicated micro-controller, the USB to serial firmware can be reprogrammed and upgraded. Explore One uses CP2102 from Si Labs. |
| Power Management | Uses comparator to detect USB power and jack power. | None | Makes better power management |
| Design Software | Eagle | KiCAD | KiCAD is opensource PCB Design Software, check our tutorials here |
| Manufacturing Country | Italy | India | hence a affordable here! |