Revision as of 11:41, 14 November 2014

The Explore Starter Kit for AVR bundles everything that is required to get kick started for AVR development. It comes with Starter AVR USB development board and host of other component, that quickly help you learn the internal details of the MCU as well as experiment with external interfaces.

Kit Includes

Starter_AVR_USB Development Board
LCD 16 x 2
DIP Switch
LEDs 5mm x20
LED RGB x2
7 Segment
Buzzer
Relay
DC Motor
Light Dependent Resistor (LDR)
Temperature Sensor (LM35)
IR pair
Transistor BC547
Resistors: 1K, 10K (10 each)
USB Cable 1
Jumper wires male to female x10
Breadboard

Physical Features

Dimensions: 70mm X 90mm
1.6mm Glass Epoxy, FR4 PCB
Wave Soldered.

Downloads:

Setting up the XploreFlash Programmer

Step 1: Xplore flash is based on various opensource software, it requires avrdude. Avrdude is part of WinAVR GCC complier. Download and install it.

Step 2:To connect Development board with computer USB driver is required. Windows USB to UART Drivers for CP2102

For Other Operating system please download from Silicon Labs website.

Step 3: Download and install XploreFlash GUI. (XploreFlash GUI is based on AVRDUDESS)

Step 4: Follow the steps on images below to flash the board.

Note: The GUI software will require .NET framework 2.0 or later please download and install it.

Support

For Questions, technical support and feedback about this product, do comment below!

@@ Line 3: / Line 3: @@
 The Explore Starter Kit for AVR bundles everything that is required to get kick started for AVR development. It comes with [[Starter AVR USB]] development board and host of other component, that quickly help you learn the internal details of the MCU as well as experiment with external interfaces.
 }}
-[[File:Explorers_Starter_Kit_for_AVR.jpg|Fig 1: AVR Starter]]
+[[File:Explorers_Starter_Kit_for_AVR.jpg|x450px|Fig 1: AVR Starter]]

Difference between revisions of "Explore Starter Kit for AVR"