8051 Starter USB Development kit is designed kick start your 8051 Development without any hassles. The Kit was made after a lot of thought on making it the best combination of easily available parts with minimal cost and great quality. Keeping in mind that this being used by hobbyists, learners and students there are chances of MCU going bad, hence we choose a low cost AT89S52, which is easily available at great price! Our intent was to make the kit complete in all aspects, ready to go!

Kit Contents

Kit Contains:

8051 Starter USB Development Board with AT89s52 MCU
USBasp based AT89S Series Programmer
Power Adapter 12V 1A
LCD 16 x 2
Switches 12mm (x2)
LEDs 5mm x20
LED RGB x2
7 Segment
Buzzer
Relay
Pot 10K
DC Motor
Light Dependent Resistor (LDR)
Temperature Sensor (LM35)
Transistor BC547
Resistors: 1K, 10K (10 each)
USB Cable 1
Jumper wires male to female x15
Breadboard

Downloads

USB Driver

To connect Development board with computer USB driver is required.

Windows USB to UART Drivers for CP2102

For Other Operating system please download from Silicon Labs website.

Schematic

8051 USB Development Board Schematic

Code Library

8051 C Library

Programming Software

Setting up the XploreFlash Programmer

Step 1: Xplore flash is based on various opensource software, it requires avrdude. Avrdude is part of WinAVR GCC complier. Download and install it.

Step 2: Download and install USB driver for the programmer.

Step 3: Download and install XploreFlash GUI. (XploreFlash GUI is based on AVRDUDESS)

Step 4: Follow Step by step guide on using the programmer software XploreFlash program the micrcontroller. The GUI software will require .NET framework 2.0 or later please download and install it.

Alternate Software for flashing hex file: Prog ISP

Download progisp

Your comments motivate us to do better, your doubts and questions help us learn! Feel free to comment below

AT89S52 USB Starter Kit

Contents