Uploading Hex File Using Pickit2 Revision as of 19:10, 9 August 2016 by Sharana
In this tutorial we will see how to upload hex file using the below PICKit 2 programmer.
Installing Pickit 2 Software
Download and Install the Pickit2 software from the below link.
Pickit 2 Software Setup
Step1: Connect the Pickit2 programmer to target board as shown below. Ensure the Boot Jumper is disconnected.
Step2: Run the Pickit2 application and check the device communication as shown below.
Step3: Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again.
Step4: Import the .hex file from the menu File->Import Hex as shown below.
Step5: The Configuration bits should be set to 0x3F3A. Now click on Write to upload the hex file to target device.
Status window will show the uploading status.