(Created page with "=Flashing the hex file= In this tutorial series we are using [http://exploreembedded.com/wiki/index.php?title=Using_XploreFlash_For_USBasp_based_Programmer Xplore Flash] to tr...")
 
 
(3 intermediate revisions by the same user not shown)
Line 1: Line 1:
 +
[[category: oneMicro Atmega32]]
 +
 +
In this tutorial we will look at setting up the oneMicro ATmega32 board, install driver and flash the hex file.
 +
Once the board is setup, you can go through our AVR Tutorial series for your further exploration of the board.
 +
=Hookup=
 +
https://www.exploreembedded.com/blog/wp-content/uploads/img-collections/onemicro128_7df93bca/onemicro128_bb.jpg
 +
To use the board, you simply need to pick up a micro USB cable and connect the oneMicro to the computer. The board comes with on board USB to Serial converter CP2102. Install the CP2102 driver for your operating system. [[Cp2102 Usb-to-Serial Driver Installation|The steps for windows are covered  in this tutorial.]]
 +
 +
=Compiling=
 +
You may use AVR GCC command line to compile and use the code. If you're on windows and trying to use Atmel Studio, this [[AVR_Hardware_and_Software_Setup#Setting_up_Atmel_Studio_6:|tutorial covers all the basics on setting up and using the IDE.]]
 +
 
=Flashing the hex file=
 
=Flashing the hex file=
 
In this tutorial series we are using [http://exploreembedded.com/wiki/index.php?title=Using_XploreFlash_For_USBasp_based_Programmer Xplore Flash] to transfer the hex file to the target MCU.  
 
In this tutorial series we are using [http://exploreembedded.com/wiki/index.php?title=Using_XploreFlash_For_USBasp_based_Programmer Xplore Flash] to transfer the hex file to the target MCU.  
Line 9: Line 20:
  
 
[[file:xploreflash_6.PNG]]
 
[[file:xploreflash_6.PNG]]
 +
 +
{{DISQUS}}

Latest revision as of 18:09, 8 September 2016


In this tutorial we will look at setting up the oneMicro ATmega32 board, install driver and flash the hex file. Once the board is setup, you can go through our AVR Tutorial series for your further exploration of the board.

Hookup

onemicro128_bb.jpg To use the board, you simply need to pick up a micro USB cable and connect the oneMicro to the computer. The board comes with on board USB to Serial converter CP2102. Install the CP2102 driver for your operating system. The steps for windows are covered in this tutorial.

Compiling

You may use AVR GCC command line to compile and use the code. If you're on windows and trying to use Atmel Studio, this tutorial covers all the basics on setting up and using the IDE.

Flashing the hex file

In this tutorial series we are using Xplore Flash to transfer the hex file to the target MCU. Steps below show how to trasfer the hex file to the MCU using Xplore Flash.

  1. Open the Xplore Flash and select programmer as Arduino .
  2. Connect the board to the computer and set baud rate 19200 .
  3. Click on "detect" ,it will detect the MCU as ATmega32.
  4. After detecting the MCU browse the hex file .
  5. Then just click on Go. it will erases, Flashes and verifies the hex file.

Xploreflash 6.PNG