Line 29: Line 29:
 
|-
 
|-
 
|EEADR|| Hold the Eeprom memory address from where the data needs to be read/written.
 
|EEADR|| Hold the Eeprom memory address from where the data needs to be read/written.
|}
+
|}<br>
<br>
+
 
+
  
 
{| class="table table-striped table-hover table-condensed table-bordered"
 
{| class="table table-striped table-hover table-condensed table-bordered"

Revision as of 12:32, 18 May 2016

In this tutorial we will discuss how to access the PIC16F877A internal EEPROM memory to store and retrieve the data. Eeprom is basically used to store the non volatile data which is required to be stored even if there is power loss or controller resets.

PIC16F877A Memories

PIC16F877A comes with three memories Flash,RAM and EEPROM. Below table shows the memory capacity of PIC16F877A:

Memory Size Description
FLASH 8k-bytes Used to store the programs
RAM 368-bytes Temporary/ScratchPad memory used during program execution.
EEPROM 256-bytes Used to store the non-volatile data across power cycles



EEPROM Registers

The below table shows the registers associated with PIC16F877A UART.

Register Description
EECON1 Eeprom read/Write Control register
EECON2 Used to execute special instruction sequence(0x55-0xAA) during write
EEDATA Holds the data to be Written/Read to/from Eeprom.
EEADR Hold the Eeprom memory address from where the data needs to be read/written.

EEPCON1
7 6 5 4 3 2 1 0
EEPGD - - - WRERR WREN WR RD

EEPGD: Program/Data EEPROM Select bit
1 = Accesses program memory
0 = Accesses data memory

WRERR: EEPROM Error Flag bit
1 = A write operation is prematurely terminated
0 = The write operation completed

WREN: EEPROM Write Enable bit
1 = Allows write cycles
0 = Inhibits write to the EEPROM

WR: Write Control bit
1 = Initiates a write cycle. The bit is cleared by hardware once write is complete. The WR bit can only be set (not cleared) in software.
0 = Write cycle to the EEPROM is complete

RD: Read Control bit
1 = Initiates an EEPROM read; RD is cleared in hardware. The RD bit can only be set (not cleared) in software.
0 = Does not initiate an EEPROM read

Register Configuration