Line 14: Line 14:
  
  
<b>PINSEL:</b>
+
<b>PINSEL:</b>  
This register is used to select the function for the particular GPIO pin.  
+
One GPIO pin has a minimum one function and max of four functions. The required function can be selected by configuring the PINSEL register. As there can be up to 4 functions associated with 
  
 
<b>FIODIR:</b>
 
<b>FIODIR:</b>

Revision as of 12:27, 16 May 2015


Objective

This is first example on LPC1768 where we start with blinking the LEDs. In this tutorials we are going to discuss how to configure the LPC1768 ports for GPIO and then to use to send a low/high signal on it. Lets start blinking with LEDs and then generate the different patterns using the available LEDs.

Register Configuration

As all the LPC1768 SFRs(Special Function Registers) are defined in lpc17xx.h, this has to be included at the beginning of our project/code.

The Below registers will be used for Configuring and using the GPIOs registers for sending and receiving the Digital signals. A structure LPC_GPIOn(n= 0,1,2,3) contains all the registers for GPIO operation. Refer lpc17xx.h file for more info on the registers.


PINSEL: One GPIO pin has a minimum one function and max of four functions. The required function can be selected by configuring the PINSEL register. As there can be up to 4 functions associated with

FIODIR:

FIOSET:

FIOCLR:

Schematic

Example