(2 intermediate revisions by the same user not shown)
Line 23: Line 23:
  
  
<b>Step2:</b>
+
<b>Step4:</b>
 
Import the .hex file from the menu File->Import Hex as shown below.
 
Import the .hex file from the menu File->Import Hex as shown below.
 
[[File:PICkit 2 import hex file.png|none]]<br><br>
 
[[File:PICkit 2 import hex file.png|none]]<br><br>
Line 33: Line 33:
 
Status window will show the uploading status.<br>
 
Status window will show the uploading status.<br>
 
[[File:0PICkit2 succesful.png|none]]
 
[[File:0PICkit2 succesful.png|none]]
 +
<br><br><br>
 +
 +
Have a opinion, suggestion or feedback about this article, or technical support please comment below!
 +
{{DISQUS}}

Latest revision as of 11:52, 1 July 2016

In this tutorial we will see how to upload hex file using the below PICKit 2 programmer.

PICKIT 2 programmer.png


Installing Pickit 2 Software

Download and Install the Pickit2 software from the below link.

Pickit 2 Software Setup

Step1: Connect the Pickit2 programmer to target board as shown below. Ensure the Boot Jumper is disconnected.

PICkit2andstater.jpeg



Step2: Run the Pickit2 application and check the device communication as shown below.

PICkit2 check communication.png


Step3: Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again.

PICKit2 application software.png



Step4: Import the .hex file from the menu File->Import Hex as shown below.

PICkit 2 import hex file.png



Step5: The Configuration bits should be set to 0x3F3A. Now click on Write to upload the hex file to target device.
Status window will show the uploading status.

0PICkit2 succesful.png




Have a opinion, suggestion or feedback about this article, or technical support please comment below!