(Created page with "Category:Arduino Tutorials 680px")
 
 
(2 intermediate revisions by one other user not shown)
Line 1: Line 1:
 
[[Category:Arduino Tutorials]]
 
[[Category:Arduino Tutorials]]
 
[[File:Arduino Interface DC Motor.JPG|680px]]
 
[[File:Arduino Interface DC Motor.JPG|680px]]
 +
 +
==Code==
 +
<syntaxhighlight>
 +
/*
 +
  Let the motors run!
 +
  Turns on an Motor on for Two second, then off for one second, repeatedly.
 +
 +
*/
 +
 +
// Pin 13 has an LED, also connected Motor.
 +
// give it a name:
 +
int led = 13;
 +
// the setup routine runs once when you press reset:
 +
void setup() {               
 +
  // initialize the digital pin as an output.
 +
  pinMode(led, OUTPUT);   
 +
}
 +
// the loop routine runs over and over again forever:
 +
void loop() {
 +
  digitalWrite(led, HIGH);  // turn the Motor on (HIGH is the voltage level)
 +
  delay(2000);              // wait for Two second
 +
  digitalWrite(led, LOW);    // turn the Motor off by making the voltage LOW
 +
  delay(1000);              // wait for a second
 +
</syntaxhighlight>

Latest revision as of 09:03, 20 September 2014

Arduino Interface DC Motor.JPG

Code

/*
  Let the motors run!
  Turns on an Motor on for Two second, then off for one second, repeatedly.
 
 */
 
// Pin 13 has an LED, also connected Motor.
// give it a name:
int led = 13;
// the setup routine runs once when you press reset:
void setup() {                
  // initialize the digital pin as an output.
  pinMode(led, OUTPUT);     
}
// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(led, HIGH);   // turn the Motor on (HIGH is the voltage level)
  delay(2000);               // wait for Two second
  digitalWrite(led, LOW);    // turn the Motor off by making the voltage LOW
  delay(1000);               // wait for a second