Liquid Crystal Displays with Explore M3 Revision as of 10:55, 9 June 2016 by Sandeep (Talk | contribs) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Character Liquid crystal displays are very handy and extremely simple to use. In this tutorial let us hook up 16x1, 16x2, 20x4 displays and test them with Explore M3. We will be using the LiquidCrystal Arduino library to accomplish this.

Hook up

There are various modes in which these displays can be connected to Explore M3 as shown below. It is combination of using 8 bit or 4 bits as database and using or not using the RW line on the display.

• LiquidCrystal(rs, enable, d4, d5, d6, d7)
• LiquidCrystal(rs, rw, enable, d4, d5, d6, d7)
• LiquidCrystal(rs, enable, d0, d1, d2, d3, d4, d5, d6, d7)
• LiquidCrystal(rs, rw, enable, d0, d1, d2, d3, d4, d5, d6, d7)

So lets use the first mode which needs the least of the pins. The potentiometer is used to set the display contrast and resistor limits current to the LCD back-light.

Code

// include the library code:
#include <LiquidCrystal.h>
 
// initialize the library with the numbers of the interface pins
LiquidCrystal lcd(12, 11, 5, 4, 3, 2);
 
void setup() {
  // set up the LCD's number of rows and columns: 
  lcd.begin(16, 2);
  // Print a message to the LCD.
  lcd.print("hello, world!");
}
 
void loop() {
  // set the cursor to column 0, line 1
  // (note: line 1 is the second row, since counting begins with 0):
  lcd.setCursor(0, 1);
  // print the number of seconds since reset:
  lcd.print(millis()/1000);
}

20 x 4 Character LCD

//Demonstrates use of 20x4 character display on Explore M3
 
#include <LiquidCrystal.h>
LiquidCrystal lcd(12, 11, 5, 4, 3, 2);
 
void setup() {
  lcd.begin(20,4); // 20 Characters on 4 lines
}
 
void loop() {
  lcd.setCursor(0, 0);
  lcd.print("Explore M3");
  lcd.setCursor(0, 1);
  lcd.print("Character LCD");
  lcd.setCursor(0, 2);
  lcd.print("4 lines");
  lcd.setCursor(0, 3);
  lcd.print("20 Characters ;)");
}

Demo

The same hookup can be used to interface 16x1, 16x4 and 20x4 displays. The only things that will change is

 lcd.begin(16, 2);  //for 16x2 display
 lcd.begin(16, 1);  //for 16x1 display
 lcd.begin(20, 4);  //for 20x4 display
 
lcd.setCursor(0, 1); //can be used to set the cursor, according to the display size.

References

• LiquidCrystalDisplay tutorial on Arduino Website