Tit, a supercharged Arduino Pro Mini with Atmega328pb
Revision as of 14:09, 5 May 2016 by Sandeep (Talk | contribs)

Ever wanted to have two hardware Serial Ports, two SPI, two I2C and more PWM pins on the Arduino Pro Mini? Tit has all of this, and retains the same form factor. Tit uses Atmega328PB at its core.

Tit, is pin compatible with Arduino Pro Mini, the chip Atmega328pb is software compatible with Atmega328p. Hence all the existing code and libraries should work without any changes. Tit uses higher version of avr-gcc toolchain, we have bundled it up as a package along with additional libraries required to access the extra features. Check the setup section on installing support for the board in the Arduino IDE. Tit-2.JPG

  • Pinout Diagram

  • Size

  • On Mini Breadboard

Features

Setup on Windows

  1. Download the Tit-Windows support files.
  2. Extract the content \hardware directory of your arduino sketch directory.
  3. After extracting the directory structure should look like ..\Documents\Arduino\hardware\Tit-Windows
  4. Open the Arduino IDE, select the board as Tit, and verify if the sketch compiles.
Tit Compile.png


Note:To get the latest version you may check the latest release on github

To upload the sketch connect a USB to Serial device with FTDI or CP2102 etc as shown in the image below. Verify the COM Port and hit upload. (Install the drivers if you're using the USB to serial board for the first time.)

Setup on Linux 64 bit

  1. Download the Linux-64 support files.
  2. Extract the content \hardware directory of your arduino sketch directory.
  3. After extracting the directory structure should look like ..\Arduino\hardware\Tit-Linux-64
  4. Open the Arduino IDE, select the board as Tit, and verify if the sketch compiles.
Tit linux-64.png


Setup on MAC

Examples

References and Credits

Retrieved from "https://exploreembedded.com/wiki/index.php?title=Tit,_a_supercharged_Arduino_Pro_Mini_with_Atmega328pb&oldid=8758"