Guru (talk) 20:00, 17 November 2015 (IST)
Objective
After blinking the leds and Controlling them using switches, its time to make some noise using the buzzer. In the first part of the tutorial, we will beep the buzzer with a delay of 1sec. At the end we will control the buzzer using a switch.
Register Configuration
Please refer the below tutorial for basics of GPIO register configuration.
Buzzer Beep Code
Below points needs to be considered for this example.
- Include the io.h file as it has the definitions for all the PORT registers.
- Include delay.h file to use the delay functions.
- Configure the PORT as Output before writing any data to PORT pins.
- Turn ON and OFF the buzzer with a delay of 1sec.
Wiring diagram
