Flashing the Hex file using ds30 bootloader Revision as of 10:18, 10 August 2015 by Sandeep (Talk | contribs) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Sharana (talk) 13:47, 7 August 2015 (IST)

---

Flashing the Hex file using ds30 bootloader

STEP 1: Download and install the DS30 bootloader gui.

Connect the board with USB to Serial shield and connect jumper as shown in images

Step 2:

• Browse the hex file
• Select the appropriate MCU
• Select the baud rate as 9600
• Select the correct com port detected on your computer, when using USB to serial convertor check for exact COM port number in device manager

Step 3: The board uses DTR pin of the CP2102 USB to Serial Convertor to reset the MCU. Set it up as shown in the image below.

Step 4: Click on the write option to flash the hex file,. Images below show the sequence.

• 

  ...detects bootloader

• 

  ...finishes flashing.

• PICKit 2 Programmer
• DS30 bootloader gui
• DS30 bootloader HEX File