Interfacing Seven Segment Displays with AVR Revision as of 10:22, 20 November 2014 by Sandeep (Talk | contribs) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

In this tutorial we will looking at interfacing a Seven Segment Display to Atmega32 MCU. We will also look at multiplexing 4 seven segment displays and programming them.

Seven Segment Display

fig 1: Basic 7 segment Display

fig 2: Simulation

Well, the name 7 segments implies there are 7 LED segments arranged as shown in figure 1. After LEDs they are the easiest interfaces to a microcontroller. There is also a decimal point or dp. It is used when decimal digits like 5.1 etc are displayed.

Applications

Seven segment are widely used in applications where digits[0-9] are required to be displayed.Although they also display letters A to F as shown in figure(2) simulation. This is a very simple and convenient way to display numbers in a bright fashion.

Form Factor

• Sizes:They come in various sizes; 0.28”, 0.3”, 0.32”, 0.36”, 0.39”, 0.4”, 0.5”, 0.56”, 0.6”, 0.8”, 1.0”, 1.2”, 1.5”, 1.8”, 2.0”, 2.3”, 3.0”, 4.0”, 5.0”, 7.0”)
• Colors: and varied colors too; Red, Green, Yellow, Orange, Blue, and White.

Working

fig 3:Common Cathode Display

fig 4: Common Anode 7 segment

Since these are basically LEDs arranged as a group they can either have anode in common or cathode.

• Common Cathode: This type of 7 segments, requires a positive voltage(5v) to given to the segments a to g in order to glow. This is shown in figure(3). Providing a positive voltage with respect to common cathode makes the LED forward biased.
• Common Anode: This type of 7 segments, requires a negativevoltage(GND) to given to the segments a to g in order to glow. This is shown in figure(4). A ground connection to cathode with respect to common anode again forward biases the LED which glows.
  

Interfacing Single Seven Segment Display

Schematic

The seven segment is interfaced as shown in the schematic below. Notice that sending a logic one to segments a to g will turn them ON. With that we can create a sequence.

Schematic:4Segments

Code

#include <avr/io.h>
#include <util/delay.h>
PORTC = 0XFF;
uint8_t seg_code[] = {0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,
                                 0x07,0x7f,0x6f,0x77,0x7c,0x39,0x5e,0x79,0x71};
uint8_t cnt =0;
int main(void)
{
	while(1)
	{
		for(cnt =0; cnt<16; cnt++)
		{
			PORTC = seg_code[cnt];
			_delay_ms(1000);			
		}		
	}
}

Code and explanation will be updated soon..