Setting up oneMicro Atmega32 Revision as of 18:06, 8 September 2016 by Sandeep (Talk | contribs) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

In this tutorial we will look at setting up the oneMicro ATmega32 board, install driver and flash the hex file.

Hook up

Simply connect the board to the computer using a micro-usb cable and you're ready to go.

Flashing the hex file

In this tutorial series we are using Xplore Flash to transfer the hex file to the target MCU. Steps below show how to trasfer the hex file to the MCU using Xplore Flash.

1. Open the Xplore Flash and select programmer as Arduino .
2. Connect the board to the computer and set baud rate 19200 .
3. Click on "detect" ,it will detect the MCU as ATmega32.
4. After detecting the MCU browse the hex file .
5. Then just click on Go. it will erases, Flashes and verifies the hex file.