Setting Up ARM GCC For ExploreM3 LPC1768
Revision as of 08:26, 25 April 2016 by Explorer (Talk | contribs)

In this tutorial we will see how to setup ARM GCC Tool Chain to generate .hex and .bin file for LPC1768.
To start with you will require ARM GCC, winAvr and make utility, download all the software's from following links.


Downloads

ARM GCC
WinAvr
Make Utility

Installing ARM GCC

Once ARM GCC is downloaded install it on your machine. At the End of the installation do select the option Add path to environment variable as shown below. File:ARM GGC 01.png


To test the ARM GCC open the command line and use command arm-none-eabi-gcc -v, which will give the version information as shown below. File:ARM GGC 02.png

Installing WinAvr

Run the winavr installer to Install winavr. Follow the installer steps to set the default configuration.


Installing Make Utility

Finally install the make utility.
Make utility will not update the path variables and it needs to be done manually. Add the Make Utility path to the environment path.

Now type the command make -v to verify the path.
Output of the command should be the version number of make file as shown in below image. File:ARM GGC 02.png

Procedure

We will compile a simple Led Blinking program for LPC1768 using ARM GCC using following procedure

  1. There are different ways to access your files depending on the makefile. We can write makefile as per our folder structure and where we are storing different files. As per the makefile we are using make one folder in your local directory where you will store all your source and header files
  2. Along with the makefile, main and all other library files, keep all following files in this folder 
          Core Support: core_cm3.c, core_cm3.h, core_cm3.o

          Device Support: system_LPC17xx.c, system_LPC17xx.h, lpc17xx.h

          Startup file: startup_LPC17xx.c

          Linker Script: LPC17xx.ld
  1. You can get all these files from Github

File:ARM GGC 03.png

  1. After that open command line in your local directory and compile program by using make Clean followed by make all command.

File:ARM GGC 04.png

File:ARM GGC 05.png


File:ARM GGC 06.png


File:ARM GGC 07.png

  1. After compilation is over hex and bin file gets generated which can be flashed to our LPC1768 board directly.

Retrieved from "https://exploreembedded.com/wiki/index.php?title=Setting_Up_ARM_GCC_For_ExploreM3_LPC1768&oldid=8287"