Flashing the Hex file using ds30 bootloader
Revision as of 14:09, 7 August 2015 by Sharana (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Sharana (talk) 13:47, 7 August 2015 (IST)

Flashing the bootloader

Download and install the PICKit 2 Programmer.

Connect the board with programmer as shown in the image

Open the PICkit 2 Programmer Click on Tools and Click on Check Communication

If connections are fine, Controller and Programmer will detect

Click on File and Import the Downloaded HEX file

HEX File is Imported sucessfully

Click on Write

Flashing the Hex file using ds30 bootloader

STEP 1: Download and install the DS30 bootloader gui.

Connect the board with USB to Serial shield and connect jumper as shown in images

Step 2:

Browse the hex file
Select the appropriate MCU
Select the baud rate as 9600
Select the correct com port detected on your computer, when using USB to serial convertor check for exact COM port number in device manager

Step 3: The board uses DTR pin of the CP2102 USB to Serial Convertor to reset the MCU. Set it up as shown in the image below.

Step 4: Click on the write option to flash the hex file,. Images below show the sequence.

<hovergallery maxhoverwidth=600 maxhoverheight=600> File:DS30 Step2.PNG

Downloads