Blinky with AVR Breakout Revision as of 10:11, 20 April 2016 by Nitish (Talk | contribs) (diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

In this tutorial we will get hands on with AVR breakout board. Here we will interface simple LED with one of the port pins. For this tutorial we will require a breadboard, LEDs and resistors.

Basics

All the port pins of the Atmega 32 are taken out on breakout board so that you can easily interface any peripheral with it. We will connect the LED to PORT B0 as shown below.Usually 220,470 or 1k ohm resistor is used as a current limiting resistor to prevent the LED from blowing up.

Refer the AVR I/O Register Configuration tutorial for basics of GPIO register configuration.

Hook up

Demo

Downloads

Download the complete project folder from the below link: https://github.com/ExploreEmbedded/AVR-MCU-Breakout-Board/archive/master.zip

Have a opinion, suggestion , question or feedback about the article let it out here!