Difference between revisions of "B Let the motors run!"

Revision as of 10:05, 16 September 2014

Code

/*
  Let the motors run!
  Turns on an Motor on for Two second, then off for one second, repeatedly.
 
 */
 
// Pin 13 has an LED, also connected Motor.
// give it a name:
int led = 13;
// the setup routine runs once when you press reset:
void setup() {                
  // initialize the digital pin as an output.
  pinMode(led, OUTPUT);     
}
// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(led, HIGH);   // turn the Motor on (HIGH is the voltage level)
  delay(2000);               // wait for Two second
  digitalWrite(led, LOW);    // turn the Motor off by making the voltage LOW
  delay(1000);               // wait for a second

@@ Line 2: / Line 2: @@
 [[File:Arduino Interface DC Motor.JPG|680px]]
+==Code==
 <syntaxhighlight>
 /*