Difference between revisions of "B Let the motors run!"

    (Created page with "Category:Arduino Tutorials 680px")
     
    Line 1: Line 1:
     
    [[Category:Arduino Tutorials]]
    		 
    [[Category:Arduino Tutorials]]
     
    [[File:Arduino Interface DC Motor.JPG|680px]]
    		 
    [[File:Arduino Interface DC Motor.JPG|680px]]
     +
     +
    <syntaxhighlight>
     +
    /*
     +
      Let the motors run!
     +
      Turns on an Motor on for Two second, then off for one second, repeatedly.
     +
     +
    */
     +
     +
    // Pin 13 has an LED, also connected Motor.
     +
    // give it a name:
     +
    int led = 13;
     +
    // the setup routine runs once when you press reset:
     +
    void setup() {               
     +
      // initialize the digital pin as an output.
     +
      pinMode(led, OUTPUT);   
     +
    }
     +
    // the loop routine runs over and over again forever:
     +
    void loop() {
     +
      digitalWrite(led, HIGH);  // turn the Motor on (HIGH is the voltage level)
     +
      delay(2000);              // wait for Two second
     +
      digitalWrite(led, LOW);    // turn the Motor off by making the voltage LOW
     +
      delay(1000);              // wait for a second
     +
    </syntaxhighlight>

    Revision as of 10:04, 16 September 2014

    Arduino Interface DC Motor.JPG 

    1. /*
    2.   Let the motors run!
    3.   Turns on an Motor on for Two second, then off for one second, repeatedly.
    4.  
    5.  */
    6.  
    7. // Pin 13 has an LED, also connected Motor.
    8. // give it a name:
    9. int led = 13;
    10. // the setup routine runs once when you press reset:
    11. void setup() {                
    12.   // initialize the digital pin as an output.
    13.   pinMode(led, OUTPUT);     
    14. }
    15. // the loop routine runs over and over again forever:
    16. void loop() {
    17.   digitalWrite(led, HIGH);   // turn the Motor on (HIGH is the voltage level)
    18.   delay(2000);               // wait for Two second
    19.   digitalWrite(led, LOW);    // turn the Motor off by making the voltage LOW
    20.   delay(1000);               // wait for a second
    Retrieved from "https://exploreembedded.com/wiki/index.php?title=B_Let_the_motors_run!&oldid=2438"