Difference between revisions of "8 Lets measure the light in the room with LDR"
Line 4: | Line 4: | ||
<syntaxhighlight> | <syntaxhighlight> | ||
/* | /* | ||
− | + | Measure The Light | |
Turns on an LED on , then off , repeatedly according to the Light. | Turns on an LED on , then off , repeatedly according to the Light. | ||
Revision as of 23:49, 12 September 2014
Code
/* Measure The Light Turns on an LED on , then off , repeatedly according to the Light. This example code is in the public domain. */ // Pin 13 has an LED connected on most Arduino boards. // LDR is connected as shown in Diagram. // give it a name: int led = 13; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(led, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(led, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }