Difference between revisions of "PIC Starter USB Development Board"
| Line 3: | Line 3: | ||
''The Ultimate PIC Starter USB Development Board comes with PIC 16F877A MCU with inbuilt serial bootloader, USB to UART convertor eliminating need of a external programmer! The board also has 16x2 LCD Breakout, test switch, LEDs and all pins of the MCU taken out. This will help you get started with PIC development.'' | ''The Ultimate PIC Starter USB Development Board comes with PIC 16F877A MCU with inbuilt serial bootloader, USB to UART convertor eliminating need of a external programmer! The board also has 16x2 LCD Breakout, test switch, LEDs and all pins of the MCU taken out. This will help you get started with PIC development.'' | ||
[[File:PIC Starter USB With LCD.JPG|x500px]] | [[File:PIC Starter USB With LCD.JPG|x500px]] | ||
| + | }} | ||
{| | {| | ||
|- | |- | ||
| − | | [[Image:PIC Starter USB.JPG |thumbnail|highslide: | + | | [[Image:PIC Starter USB.JPG |thumbnail|highslide:Fig1]] || [[Image:PIC Starter USB (2).JPG |thumbnail|highslide:Fig2]] |
|} | |} | ||
| − | |||
| − | |||
{{Box|type=blue_dark|text= | {{Box|type=blue_dark|text= | ||
Features: | Features: | ||
Revision as of 15:47, 25 June 2014
The Ultimate PIC Starter USB Development Board comes with PIC 16F877A MCU with inbuilt serial bootloader, USB to UART convertor eliminating need of a external programmer! The board also has 16x2 LCD Breakout, test switch, LEDs and all pins of the MCU taken out. This will help you get started with PIC development.
 |
.JPG) |
Features:
- 16F877A MCU with ds30 bootloader
- LCD 16x2 breakout.
- Serial Interface RS232.
- Test switches (1) and LEDs(3).
- All Port pins pins available for peripheral interfacing.
- Dimensions: 95mm X 70mm.
- 1.6mm Glass Epoxy, FR4 PCB.
- Wave Soldered.
Flashing the Hex file using ds30 bootloader
STEP 1: Downloadand install the DS30 bootloader gui.
Step 2:
- Browse the hex file
- Select the appropriate MCU
- Select the baud rate as 9600
- Select the correct com port detected on your computer, when using USB to serial convertor check for exact COM port number in device manager
Step 3: Click on the write option to flash the hex file, RESET the board immediately so that bootloader is detected. Images below show the sequence. <hovergallery maxhoverwidth=600 maxhoverheight=600> File:DS30 Step1.PNG
Downloads