Difference between revisions of "Uploading Hex File Using Ds30 Bootloader"
| Line 1: | Line 1: | ||
[[Category:Starter PIC16F877]] | [[Category:Starter PIC16F877]] | ||
We will see in this tutorial how to upload hex file using DS30 loader GUI. | We will see in this tutorial how to upload hex file using DS30 loader GUI. | ||
| − | =Installing DS30 | + | =Installing DS30 Software= |
| − | + | Download the DS30 Loader Software from the below link and install it.<br> | |
| − | * [http://exploreembedded.com/wiki/File:Ds30LoaderGui.zip DS30 Loader GUI software] <br> | + | * [http://exploreembedded.com/wiki/File:Ds30LoaderGui.zip DS30 Loader GUI software] <br><br><br> |
=Launching DS30 Loader GUI software= | =Launching DS30 Loader GUI software= | ||
Revision as of 15:10, 24 April 2016
We will see in this tutorial how to upload hex file using DS30 loader GUI.
Installing DS30 Software
Download the DS30 Loader Software from the below link and install it.
Launching DS30 Loader GUI software
- Once we download the DS30 Loader GUI software, start the DS30 Loader GUI software by selecting Start>Programs>DS30 loader GUI .
Step 1:
- Browse the hex file
- Select the appropriate MCU
- Select the baud rate as 9600
- Select the correct com port detected on your computer, when using USB to serial converter check for exact COM port number in device manager.
Step 2: The board uses DTR pin of the CP2102 USB to Serial Converter to reset the MCU. Set it up as shown in the image below.
Step 3: Click on the write option to flash the hex file. Once hex file is successfully uploaded status window display Write successfully completed Refer below image.
Have a opinion, suggestion , question or feedback about the article let it out here!