Difference between revisions of "Blinky with AVR Breakout"
Raghavendra (Talk | contribs) |
|||
| Line 15: | Line 15: | ||
=Demo= | =Demo= | ||
| + | |||
| + | [[File:0Blinky with AVR Breakout.gif|none]] | ||
| + | |||
=Downloads= | =Downloads= | ||
Revision as of 17:44, 30 March 2016
In this tutorial we will get hands on with AVR breakout board. Here we will interface simple LED with one of the port pins. For this tutorial we will require a breadboard, LEDs and resistors.
Contents
Basics
All the port pins of the Atmega 32 are taken out on breakout board so that you can easily interface any peripheral with it. We will connect the LED to PORT B0 as shown below.Usually 220,470 or 1k ohm resistor is used as a current limiting resistor to prevent the LED from blew up.
Refer the AVR I/O Register Configuration tutorial for basics of GPIO register configuration.
Hook up
Code
Demo
