Difference between revisions of "1 Blink a LED"
Line 1: | Line 1: | ||
[[Category:Arduino Tutorials]] | [[Category:Arduino Tutorials]] | ||
+ | Blinky, is your first experiment in the world of Arduino. Let's blink! | ||
=Hook Up= | =Hook Up= | ||
[[File:Aurduino Blink a LED.JPG|680px]] | [[File:Aurduino Blink a LED.JPG|680px]] | ||
+ | |||
=Code= | =Code= | ||
<syntaxhighlight> | <syntaxhighlight> |
Revision as of 16:06, 4 March 2016
Blinky, is your first experiment in the world of Arduino. Let's blink!
Hook Up
Code
- /*
- Blink a LED
- Turns on an LED on for one second, then off for one second, repeatedly.
- */
- // Pin 13 has an LED connected on most Arduino boards.
- // give it a name:
- int led = 13;
- // the setup routine runs once when you press reset:
- void setup() {
- // initialize the digital pin as an output.
- pinMode(led, OUTPUT);
- }
- // the loop routine runs over and over again forever:
- void loop() {
- digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
- delay(1000); // wait for a second
- digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
- delay(1000); // wait for a second
- }