Difference between revisions of "1 Blink a LED"

Revision as of 16:13, 15 September 2014

Code

/*
  Blink
  Turns on an LED on for one second, then off for one second, repeatedly.
 
 */
 
// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;
// the setup routine runs once when you press reset:
void setup() {                
  // initialize the digital pin as an output.
  pinMode(led, OUTPUT);     
}
// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);               // wait for a second
  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);               // wait for a second
}

@@ Line 7: / Line 7: @@
    Turns on an LED on for one second, then off for one second, repeatedly.
-  This example code is in the public domain.
   */