Difference between revisions of "PIC Starter USB Development Board"
| Line 30: | Line 30: | ||
Flashing the Hex file using ds30 bootloader}} | Flashing the Hex file using ds30 bootloader}} | ||
{{Box|type=l_green_light|text= | {{Box|type=l_green_light|text= | ||
| − | STEP 1: [http://xplorelabz.com/wiki/images/6/62/Ds30_Loader.rar Download]and install the DS30 bootloader gui. | + | STEP 1: [http://xplorelabz.com/wiki/images/6/62/Ds30_Loader.rar '''Download'''] and install the DS30 bootloader gui. |
Step 2: | Step 2: | ||
[[File:DS30 Step0.PNG|x400px|Setup Parameters]] | [[File:DS30 Step0.PNG|x400px|Setup Parameters]] | ||
| Line 37: | Line 37: | ||
*'''Select the baud rate as 9600''' | *'''Select the baud rate as 9600''' | ||
*'''Select the correct com port detected on your computer, when using USB to serial convertor check for exact COM port number in device manager''' | *'''Select the correct com port detected on your computer, when using USB to serial convertor check for exact COM port number in device manager''' | ||
| − | Step 3: Click on the write option to flash the hex file, | + | Step 3: The board uses DTR pin of the CP2102 USB to Serial Convertor to reset the MCU. Set it up as shown in the image below. |
| + | [[File:AUTO RESET.png|x300px|Setup AutoReset]] | ||
| + | Step 4: Click on the write option to flash the hex file,. Images below show the sequence. | ||
<hovergallery maxhoverwidth=600 maxhoverheight=600> | <hovergallery maxhoverwidth=600 maxhoverheight=600> | ||
| − | |||
File:DS30 Step2.PNG|...detects bootloader | File:DS30 Step2.PNG|...detects bootloader | ||
File:DS30_Step3.PNG|...finishes flashing. | File:DS30_Step3.PNG|...finishes flashing. | ||
Revision as of 16:33, 14 August 2014
The Ultimate PIC Starter USB Development Board comes with PIC 16F877A MCU with inbuilt serial bootloader, USB to UART convertor eliminating need of a external programmer! The board also has 16x2 LCD Breakout, test switch, LEDs and all pins of the MCU taken out. This will help you get started with PIC development.
.JPG)
Features:
- 16F877A MCU with ds30 bootloader
- LCD 16x2 breakout.
- Serial Interface RS232.
- Test switches (1) and LEDs(3).
- All Port pins pins available for peripheral interfacing.
- Dimensions: 95mm X 70mm.
- 1.6mm Glass Epoxy, FR4 PCB.
- Wave Soldered.
Flashing the Hex file using ds30 bootloader
STEP 1: Download and install the DS30 bootloader gui.
Step 2:
- Browse the hex file
- Select the appropriate MCU
- Select the baud rate as 9600
- Select the correct com port detected on your computer, when using USB to serial convertor check for exact COM port number in device manager
Step 3: The board uses DTR pin of the CP2102 USB to Serial Convertor to reset the MCU. Set it up as shown in the image below.
Step 4: Click on the write option to flash the hex file,. Images below show the sequence.
<hovergallery maxhoverwidth=600 maxhoverheight=600>
File:DS30 Step2.PNG
Downloads