Difference between revisions of "8 Lets measure the light in the room with LDR"
(One intermediate revision by the same user not shown) | |||
Line 4: | Line 4: | ||
<syntaxhighlight> | <syntaxhighlight> | ||
/* | /* | ||
− | + | Lets measure the light in the room with LDR | |
Turns on an LED on , then off , repeatedly according to the Light. | Turns on an LED on , then off , repeatedly according to the Light. | ||
− | + | */ | |
− | + | ||
− | + | ||
// Pin 13 has an LED connected on most Arduino boards. | // Pin 13 has an LED connected on most Arduino boards. | ||
− | // LDR is connected as shown in Diagram. | + | // LDR is connected to analog input A0 as shown in Diagram. |
// give it a name: | // give it a name: | ||
int led = 13; | int led = 13; |
Latest revision as of 16:53, 15 September 2014
Code
/* Lets measure the light in the room with LDR Turns on an LED on , then off , repeatedly according to the Light. */ // Pin 13 has an LED connected on most Arduino boards. // LDR is connected to analog input A0 as shown in Diagram. // give it a name: int led = 13; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(led, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(led, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }