Difference between revisions of "Uploading Hex File Using Pickit2"
| (One intermediate revision by the same user not shown) | |||
| Line 32: | Line 32: | ||
Now click on Write to upload the hex file to target device.<br> | Now click on Write to upload the hex file to target device.<br> | ||
Status window will show the uploading status.<br> | Status window will show the uploading status.<br> | ||
| − | [[File:0PICkit2 succesful.png|none]] | + | [[File:0PICkit2 succesful.png|none]] <br><br> |
| + | |||
| + | Have a opinion, suggestion , question or feedback about the article let it out here! | ||
| + | {{DISQUS}} | ||
Latest revision as of 17:59, 14 March 2017
In this tutorial we will see how to upload hex file using the below PICKit 2 programmer.
Installing Pickit 2 Software
Download and Install the Pickit2 software from the below link.
Pickit 2 Software Setup
Step1: Connect the Pickit2 programmer to target board as shown below. Ensure the Boot Jumper is disconnected.
Step2:
Run the Pickit2 application and check the device communication as shown below.
Step3: Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again.
Step4:
Import the .hex file from the menu File->Import Hex as shown below.
Step5:
The Configuration bits should be set to 0x3F3A.
Now click on Write to upload the hex file to target device.
Status window will show the uploading status.
Have a opinion, suggestion , question or feedback about the article let it out here!