Difference between revisions of "Flashing Hex File Using Pickit2"
| (2 intermediate revisions by the same user not shown) | |||
| Line 23: | Line 23: | ||
| − | <b> | + | <b>Step4:</b> |
Import the .hex file from the menu File->Import Hex as shown below. | Import the .hex file from the menu File->Import Hex as shown below. | ||
[[File:PICkit 2 import hex file.png|none]]<br><br> | [[File:PICkit 2 import hex file.png|none]]<br><br> | ||
| Line 33: | Line 33: | ||
Status window will show the uploading status.<br> | Status window will show the uploading status.<br> | ||
[[File:0PICkit2 succesful.png|none]] | [[File:0PICkit2 succesful.png|none]] | ||
| + | <br><br><br> | ||
| + | |||
| + | Have a opinion, suggestion or feedback about this article, or technical support please comment below! | ||
| + | {{DISQUS}} | ||
Latest revision as of 11:52, 1 July 2016
In this tutorial we will see how to upload hex file using the below PICKit 2 programmer.
Installing Pickit 2 Software
Download and Install the Pickit2 software from the below link.
Pickit 2 Software Setup
Step1: Connect the Pickit2 programmer to target board as shown below. Ensure the Boot Jumper is disconnected.
Step2:
Run the Pickit2 application and check the device communication as shown below.
Step3: Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again.
Step4:
Import the .hex file from the menu File->Import Hex as shown below.
Step5:
The Configuration bits should be set to 0x3F3A.
Now click on Write to upload the hex file to target device.
Status window will show the uploading status.
Have a opinion, suggestion or feedback about this article, or technical support please comment below!