View source for Uploading Hex File to PIC18F4520 Using Ds30 Bootloader ← Uploading Hex File to PIC18F4520 Using Ds30 Bootloader

[[Category:Starter PIC18F4520]]
[[Category:oneMicro PIC18F4520]]

We will see in this tutorial how to upload hex file to PIC controller using DS30 loader GUI.<br><br>

  
=Installing DS30 Software=
Download the DS30 Loader Software from the below link and Extract it to some folder.<br>
* [http://exploreembedded.com/wiki/images/7/7e/Ds30LoaderGui.zip DS30 Loader GUI software] <br><br><br>

=Launching  DS30 Loader =
Run the DS30 Loader GUI software  . 

Step 1: 

#Browse the hex file
#Select the appropriate MCU
#Select the baud rate as 9600
#Select the correct com port detected on your computer, when using USB to serial converter check for exact COM port number in device manager.
[[File:DS30 PIC18F4520.png ]]<br><br>

Step 2: The board uses DTR pin of the CP2102 USB to Serial Converter to reset the MCU. Set it up as shown in the image below.
[[File:DS30 loader settings.png|none]]<br><br>

Step 3: Click on the '''write''' option to flash the hex file. Once hex file is successfully uploaded status window display '''Write successfully completed''' Refer below image.
[[File:0DS30 PIC18F4520.png]]<br><br>


Have a opinion, suggestion , question or feedback about the article let it out here!
{{DISQUS}}