View source for LPC2148: Uploading .bin file ← LPC2148: Uploading .bin file

[[category: LPC2148 Tutorials]]
=Objective=
In this tutorial, we will be discussing how to upload the .bin file to Lpc2148 board.<br>
To upload the .bin, no external hardware is required but  board should have the secondary boot loader.<br><br><br>

=Generating .bin File=
Check this tutoial [[LPC1768: Keil Project For Bin File|LPC1768 Keil Setup]]  for generating the .bin file using keil.<br><br><br>

=.Bin File Using Secondary Boot Loader=
For uploading the .bin file, secondary(USB) boot-loader needs to be flashed to the controller. Even though we put a USB bootloader, the serial bootloader will be still present to flash the hex files using Flash Magic.

Follow the below steps to upload the new .bin file to LPC1768 board:
#Connect the USB Jumpers.
#Connect the ExploreLpc2148 to the system using a USB cable.
#Hold the USB_Btlr switch.
#Press the Reset Switch.
#Release the Reset Switch.
#Release the USB_Btlr switch.
#Now the board will be detected as Explore2148
#Delete the old firmware.bin file.
#Paste the new .bin file.
#Reset the Board.
#Now your Application code should be running on the board.<br><br>

[[File:LPc1768_UsbBootLoader.jpg|x400px]]
<br><br><br>

Have an opinion, suggestion , question or feedback about the article let it out here!
{{DISQUS}}