View source for Blinky with Atmega128 Breakout ← Blinky with Atmega128 Breakout

[[category:Atmega128 Breakout]]
In this tutorial we will get hands on with Atmega128 breakout board. Here we will interface simple LED with one of the port pins. For this tutorial we will require a breadboard, LED and resistor.
=Basics=
All the port pins of the Atmega128 are taken out on breakout board so that you can easily interface any peripheral with it. We will connect the LED to PORT B0 as shown below.Usually 220,470 or 1k ohm resistor is used as a current limiting resistor to prevent the LED from blowing up.

Refer the [[AVR I/O Register Configuration]] tutorial for basics of GPIO register configuration.

=Hook up=
[[File:ATmega128breakout blinky.png|none]]

=Code=
<html>
<script src="https://gist.github.com/nitishshete/0151f0832a9f729f3d42c65317c89022.js"></script>
</html>

=Demo=

[[File:0Blinky with Atmega128 Breakout.gif|none]]

=Downloads=