View source for Setting up oneMicro Atmega32 ← Setting up oneMicro Atmega32

In this tutorial we will look at setting up the oneMicro ATmega32 board, install driver and flash the hex file.
=Hook up=
Simply connect the board to the computer using a micro-usb cable and you're ready to go.
https://www.exploreembedded.com/blog/wp-content/uploads/img-collections/onemicro-atmega32/dsc09607_3-001.jpg 
=Flashing the hex file=
In this tutorial series we are using [http://exploreembedded.com/wiki/index.php?title=Using_XploreFlash_For_USBasp_based_Programmer Xplore Flash] to transfer the hex file to the target MCU. 
''Steps below show how to trasfer the hex file to the MCU using Xplore Flash.''
# Open the Xplore Flash and select programmer as '''Arduino''' .
# Connect the board to the computer and set baud rate '''19200''' .
# Click on "detect" ,it will detect the MCU as '''ATmega32'''.
# After detecting the MCU browse the hex file .''
# Then just click on '''Go'''. it will erases, Flashes and verifies the hex file.

[[file:xploreflash_6.PNG]]