Difference between revisions of "Uploading Hex File Using Pickit2"
| Line 9: | Line 9: | ||
=Pickit 2 Software Setup= | =Pickit 2 Software Setup= | ||
| − | <b>Step1 | + | <b>Step1:</b> |
| − | + | Connect the Pickit2 programmer to target board as shown below. <b>Ensure the Boot Jumper is disconnected</b>. | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | Connect the Pickit2 programmer to target board as shown below. Ensure the | + | |
[[File:PICkit2andstater.jpeg#sthash.oRFNF44v.dpuf|none]]<br><br> | [[File:PICkit2andstater.jpeg#sthash.oRFNF44v.dpuf|none]]<br><br> | ||
| − | <b> | + | <b>Step2:</b> |
| − | Run the Pickit2 application and check the device communication.<br> | + | Run the Pickit2 application and check the device communication as shown below.<br> |
| − | + | ||
[[File:PICkit2 check communication.png|none]] <br><br> | [[File:PICkit2 check communication.png|none]] <br><br> | ||
| + | <b>Step3:</b> | ||
Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again<br><br> | Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again<br><br> | ||
* Refer the below labeled image of PICkit 2 programmer application software. | * Refer the below labeled image of PICkit 2 programmer application software. | ||
| Line 28: | Line 24: | ||
| − | <b> | + | <b>Step2:</b> |
Import the .hex file from the menu File->Import Hex as shown below. | Import the .hex file from the menu File->Import Hex as shown below. | ||
[[File:PICkit 2 import hex file.png|none]]<br><br> | [[File:PICkit 2 import hex file.png|none]]<br><br> | ||
Revision as of 14:01, 3 May 2016
In this tutorial we will see how to upload hex file using the below PICKit 2 programmer.
Installing Pickit 2 Software
Download and Install the Pickit2 software from the below link
Pickit 2 Software Setup
Step1: Connect the Pickit2 programmer to target board as shown below. Ensure the Boot Jumper is disconnected.
Step2:
Run the Pickit2 application and check the device communication as shown below.
Step3:
Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again
- Refer the below labeled image of PICkit 2 programmer application software.
Step2:
Import the .hex file from the menu File->Import Hex as shown below.
Step5:
The Configuration bits should be set to 0x3F3A.
Now click on Write to upload the hex file to target device.
Status window will show the uploading status.
