(Created page with "Category:Starter PIC18F4520 In this tutorial we will see how to upload hex file using the below [https://www.exploreembedded.com/product/PIC%20USB%20Programmer PICKit 2 pr...")
 
Line 20: Line 20:
 
<b>Step3:</b>
 
<b>Step3:</b>
 
Now status window should show  PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again.
 
Now status window should show  PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again.
[[File:PICKit2 application software.png|none]]<br><br>
+
[[File:Flashing HEX file to pic18f4520.png]]<br><br>
  
  
Line 32: Line 32:
 
Now click on Write to upload the hex  file to target device.<br>
 
Now click on Write to upload the hex  file to target device.<br>
 
Status window will show the uploading status.<br>
 
Status window will show the uploading status.<br>
[[File:0PICkit2 succesful.png|none]]
+
[[File:Flashing HEX file to pic18f4520 1.png.png|none]]

Revision as of 17:56, 9 August 2016

In this tutorial we will see how to upload hex file using the below PICKit 2 programmer.

PICKIT 2 programmer.png


Installing Pickit 2 Software

Download and Install the Pickit2 software from the below link.

Pickit 2 Software Setup

Step1: Connect the Pickit2 programmer to target board as shown below. Ensure the Boot Jumper is disconnected.

PICkit2andstater.jpeg



Step2: Run the Pickit2 application and check the device communication as shown below.

PICkit2 check communication.png


Step3: Now status window should show PICkit 2 connected, with proper device(PIC16F877A), else double check the connections and try again. Flashing HEX file to pic18f4520.png


Step2: Import the .hex file from the menu File->Import Hex as shown below.

PICkit 2 import hex file.png



Step5: The Configuration bits should be set to 0x3F3A. Now click on Write to upload the hex file to target device.
Status window will show the uploading status.