In this tutorial we will set up and read the temperature from LM35 using ADC of Atmega32 AVR breakout.

Basics

Initially we will read a raw data from ADC. Atmega32 comes with 10-bit 8-channel inbuilt ADC. We will connect 10k Pot to channel 0, vary it and read the raw voltage. After that we will connect the LM35 temperature sensor to channel 0 and read the temperature as shown in hook up. We will display the converted value on terminal.
Refer Reading Temperature with AVR ADC for basics of Atmega32 ADC and LM35 temperature sensor.

Hook Up LM35

Avrbreakout ADC temp.png Instead of LM35 temperature we can connect Pot to read the raw data from ADC.

Code to Read Voltage

Code to Read Temperature


To display the ADC value open the terminal connect the COM port, we will get output as shown in below image. ADC temp.PNG